Cisco 600W User Manual download pdf (Page 7)

600W AC-Input Power Supply and Fan Tray Replacement Instructions 7

Prerequisites

Tools and Equipment

This section lists the tools and equipment you will need to complete these replacement procedures.

Have the following tools on hand so that you can complete the replacement without interruption:

• 3/16-inch, ﬂat-blade screwdriver to loosen the captive screws on the chassis cover panel

• Number 1 Phillips screwdriver to remove the M3 Phillips screws on the power harness cover (you

must remove the power harness cover to replace the power supply)

• Number 2 Phillips screwdriver to remove the M4 Phillips screw on the power supply and the fan

tray

• Antistatic mat or antistatic foam pad if you are replacing the fan tray

• Your own ESD grounding strap or the disposable ESD strap that is included with all spares

If the chassis is mounted in an equipment rack, ensure that there is at least 1 foot of clearance at the

noninterface processor end to remove the power supply or fan tray, both of which you must pull

straight out of the chassis.

If a power strip or other equipment obstructs access, you will have to remove the chassis from the

rack before replacing the component. Refer to the Cisco 7010 Hardware Installation and

Maintenance or Cisco 7505 Hardware Installation and Maintenance publications for the tools you

will need and descriptions of the rack mounting hardware.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

Cisco 600W User Manual Page 7