Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Troubleshooting Guide download pdf (Page 34)

Send documentation comments to mdsfeedbac[email protected]

Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.2(3)

OL-14116-04

Caveats

• CSCsl65951

Symptom: Using Fabric Manager Release 3.2(2), an error is displayed in the creation wizard. This

occurs when an enclosure spans multiple fabrics and not all fabrics are managed and when the Data

Migration Wizard is used to create a job with that enclosure as the existing storage (selecting all ports

listed in that enclosure).

Workaround: Put the ports you plan to use as the existing storage in the migration into a separate

enclosure, and use that enclosure in the wizard selection.

• CSCsi56167

Symptom: The response time shown in the output of a ping ip-address command may not be accurate if

there is an MDS MSM-8/4 in the path.

Workaround: Use the ips measure-rtt command to measure the round trip time.

• CSCsk91974

Symptom: When you issue the show tech-support sme or the show klm internal isapi_scsi command

after attaching to a module, you may see this error message:

cat: write error: Bad address. This

issue does not affect the actual tech-support log.

Workaround: None.

• CSCsk73654

Symptom: In certain tape libraries, the tape drives are exported as LUNs. If these target ports are already

a part of a Cisco SME configuration and new tape drives are added as LUNs, the new tape drives will not

be discovered during a Cisco SME tape group or tape device configuration.

Workaround: Perform a rescan at the host level or a flap of the target port to allow Cisco SME to

rediscover these newly added tape drives.

• CSCsk43927

Symptom: The following Fabric Manager client components that use SSH and Telnet do not work

well with NAT:

• DMM storage job creation

• Cisco SAN-OS software upgrade

• Zone activation

Workaround: None.

• CSCsk90998

Symptom: The signal loss counters in the output of the show interface fcx/y command are not

incremented.

Workaround: None.

• CSCsm13002

Symptom: In rare cases, if a READ command issued by Cisco SME for media identification is

dropped or lost, the tape is marked as a clear-text tape. Subsequently, a CHECK_CONDITION with

ILI is returned when a READ is issued by the host. This can cause a backup application to mark the

tape as read-only.

Workaround: Unmount and remount the tape from the backup application to resolve this issue.

1 2 ... 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Troubleshooting Guide Page 34

Comments to this Manuals

Related products and manuals for Processors Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor