Cisco 3526 Specifications download pdf (Page 111)

5-25

PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration

OL-3526-05

Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+

Configuring a Channelized T3 Link

Step 3 Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using

the ip address subcommand, as in the following example:

Router(config-if)# ip address 10.0.0.0 10.255.255.255

Step 4 Add any additional configuration subcommands required to enable routing protocols and set the

interface characteristics.

Step 5 Reenable the interfaces using the no shutdown command. (See the “Replacing an Existing Port

Adapter” section on page 5-2.)

Step 6 Configure all additional port adapter interfaces as required.

Step 7 After including all of the configuration subcommands to complete your configuration, press

Ctrl-Z—hold down the Control key while you press Z—or enter end or exit to exit configuration mode

and return to the EXEC command interpreter prompt.

Table 5-2 Examples of the interface serial Subcommand

Platform Command Example

Cisco 7200 series routers interface serial, followed by

port-adapter-slot/T3-port/

T1-line-number:channel-group

number

The example is for T3 port 0, T1 1,

channel group 0 of a

port adapter in port adapter slot 6.

Router(config)# interface serial

6/0/1:0

Router(config-if)#

Cisco 7301 routers interface serial, followed by

port-adapter-slot/T3-port/

T1-line-number:channel-group

number

The example is for T3 port 0, T1 1,

channel group 0 of a

port adapter in port adapter slot 1.

Router(config)# interface serial

1/0/1:0

Router(config-if)#

Cisco 7304 PCI Port Adapter Carrier

Card in a Cisco 7304 router

interface serial, followed by

port-adapter-slot/T3-port/

T1-line-number:channel-group

number

The example is for T3 port 0, T1 1,

channel group 0 of a port adapter in a Cisco

7304 PCI Port Adapter Carrier Card in

module slot 3 of a Cisco 7304 router.

Router(config)# interface serial

1/0/1:0

Router(config-if)#

Cisco 7401ASR routers interface serial, followed by

port-adapter-slot/T3-port/

T1-line-number:channel-group

number

The example is for T3 port 0, T1 1,

channel group 0 of a port adapter in port

adapter slot 1.

Router(config)# interface serial

1/0/1:0

Router(config-if)#

VIP in Cisco 7000 series or Cisco 7500

series routers

interface serial, followed by

interface-processor-slot/

port-adapter-slot/

T3-port/T1-line-number:

channel-group number

The example is for T3 port 0, T1 1,

channel group 0 of a port adapter in port

adapter slot 1 of a VIP in interface processor

slot 4.

Router(config)# interface serial

4/1/0/1:0

Router(config-if)#

1 ... 110 111 112 ... 130

Comments to this Manuals

No comments

Cisco 3526 Specifications Page 111

Comments to this Manuals

Related products and manuals for Gateways/controllers Cisco 3526