Cisco 3526 Specifications download pdf (Page 29)

1-13

PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration

OL-3526-05

Chapter 1 Overview

Identifying Interface Addresses

VIP Interface Addresses

This section describes how to identify the interface addresses used for the PA-MC-2T3+ on a VIP in

Cisco 7000 series and Cisco 7500 series routers.

Note Although the processor slots in the 7-slot Cisco 7000 and Cisco 7507 and the 13-slot Cisco 7513 and

Cisco 7576 are vertically oriented and those in the 5-slot Cisco 7010 and Cisco 7505 are horizontally

oriented, all Cisco 7000 series and Cisco 7500 series routers use the same method for slot and port

numbering.

See Table 1-4 on page 1-11 for the interface address format. The interface address is composed of a

three-part number in the format

interface-processor-slot-number/port-adapter-slot-number/interface-port-number.

If the VIP is inserted in interface processor slot 3, then the interface addresses of the PA-MC-2T3+ are

3/1/0 through 3/1/1 (interface processor slot 3, port adapter slot 1, and interfaces 0 and 1). If the

port adapter was in port adapter slot 0 on the VIP, these same interface addresses would be numbered

3/0/0 through 3/0/1.

Note If you remove the VIP with the PA-MC-2T3+ (shown in Figure 1-9 on page 1-9) from interface

processor slot 3 and install it in interface processor slot 2, the interface addresses become 2/1/0 through

2/1/1.

1 ... 28 29 30 ... 130

No comments

Cisco 3526 Specifications Page 29