Cisco 3526 Specifications download pdf (Page 48)

3-8

PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration

OL-3526-05

Chapter 3 Removing and Installing Port Adapters

Port Adapter Removal and Installation

Cisco 7301 Router—Removing and Installing a Port Adapter

84129

7411

-2

, 2

, 50

, 4

- 6

ENABLED

ATM

Step 1

Use an ESD wrist strap to ground yourself to the router.

Step 2

To remove a port adapter, use a Phillips screwdriver to turn the screw holding the port adapter latch. The screw

should be loose enough to allow the latch to rotate to an unlocked position. (See A.) The latch can rotate 360˚.

Step 3

Grasp the handle and pull the port adapter from the router, about halfway out of its slot. (See B.) If you are

removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.

Step 4

With the port adapter halfway out of the slot, diconnect all cables from the port adapter. After disconnecting

the cables, pull the port adapter from its chassis slot.

Caution

The port adapter must slide into the slot guides close to the chassis lid. (See C.) Do not allow the port

adapter components to come in contact with the system board or the port adapter could be damaged.

Step 5

To insert the port adapter, carefully align the port adapter carrier in the slot guides. (See C.) Slide the new

port adapter halfway into the chassis.

Step 6

Connect all required cables to the port adapter. After connecting all required cables, carefully slide the port

adapter all the way into the slot until the port adapter is seated in the midplane.

Step 7

After the port adapter is properly seated, turn and secure the port adapter latch in the upright, locked

position. (See A.) Tighten the screw to ensure the port adapter remains firmly in place.

1 ... 47 48 49 ... 130

No comments

Cisco 3526 Specifications Page 48