Cisco 678 Specifications download pdf (Page 101)

5-17

Cisco 600 Series Installation and Operation Guide

78-11190-01

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Enable IP Filtering

Step 4

To set a destination address for each VC, enter:

set interface wan0-0 dest 192.168.245.228

mask 255.255.255.0

Step 5

To save your changes, enter:

write

Step 6

To exit the CBOS, enter:

quit

For more information on using the

set route

command, see the

Cisco Broadband

Operating System User Guide

Enable Routing Information Protocol (RIP)

To enable RIP and RIP2 in CBOS, enter:

set rip enabled

To disable RIP, enter:

set rip disabled

For more information on using the

set rip

commands, see the

Cisco Broadband

Operating System User Guide

Enable IP Filtering

The Cisco 67x supports up to 20 filters for TCP and UDP packets passing through

the Cisco 67x’s interfaces. Enabled filters are applied to packets in sequential

order according to filter number.

To use filtering to block all packets going through the Ethernet interface, enter:

set filter 0 on deny eth0 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0

For more information on using the

set filter

command, see the

Cisco Broadband

Operating System User Guide

1 ... 100 101 102 ... 192

No comments

Cisco 678 Specifications Page 101