Cisco 678 Specifications download pdf (Page 122)

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure Line Coding (Cisco 677 and Cisco 678 only)

5-38

Cisco 600 Series Installation and Operation Guide

78-11190-01

Interleaved Symbols with CRC Errors: 0

No Cell Delineation Interleaved: 0

Header Error Check Counter Interleaved:0

Count of Severely Errored Frames: 0

Count of Loss of Signal Frames: 0

Configure for DMT2

The default line coding mode for the Cisco 677 and Cisco 678 is DMT2. The

central office hardware must be correctly configured to accept a DMT2 service

user.

Step 1

Configure the CPE for DMT. See the “Configure for DMT” section on page 5-34.

Step 2

Enter:

cbos# set interface wan0 standard t1.413

Step 3

Be sure to retrain the CPE to activate the new line code. When the CPE is

retrained, use the

show interface wan0

command to verify the DMT2 standard is

active.

Note

Changes made to the running configuration must be written

NVRAM for changes to be seen on reboot.

Sample Output of Configuration Session for DMT2

cbos#set interface wan0 standard

SET INTERFACE WANx STANDARD requires one of the following arguments

T1.413

G.lite (G992.2)

cbos#set interface wan0 standard t1.413

Note: Change will take effect on next retrain.

cbos#set interface wan0 retrain

cbos#show interface wan0

wan0 ADSL Physical Port

1 ... 121 122 123 ... 192

No comments

Cisco 678 Specifications Page 122