Cisco 678 Specifications download pdf (Page 80)

Chapter 4 Configuration Procedures for the Cisco 633

Configuring External Routers

4-6

Cisco 600 Series Installation and Operation Guide

78-11190-01

Step 1

Cable the two Cisco 633s. See the “Back-to-Back Cabling (Cisco 633 and

Cisco 673 only)” section on page 2-5 for cabling information.

Step 2

Set one Cisco 633 to central office (CO) mode, so that it terminates the traffic that

the Cisco 633 in customer premises equipment (CPE) mode initiates.

Note

The Cisco 633 ships with a default setting of CPE mode.

To set the Cisco 633 to CO mode:

set int wan0 mode co

Step 3

Set up an IWF data path between the Cisco 633s. See the “Configure

Interworking” section on page 4-3 for more information.

Step 4

Verify that both Cisco 633s are in either RFC 1483 bridging or RFC 1483 routing

mode only, not PPP (Point-to-Point Protocol) routing or bridging mode. See the

sections below for either bridging or routing procedures.

Configuring External Routers

Please consult the user documentation for your router to connect the Cisco 633 to

routers on the FR and ATM networks. The Cisco 633 can pass traffic that uses the

following protocols:

•

RFC 1483 bridging

•

PPP bridging

Upgrade Software through Serial Download

You can upgrade software on your CPE using the serial interface:

Note

Changes to your CPE must be coordinated with the central office

equipment.

1 ... 79 80 81 ... 192

No comments

Cisco 678 Specifications Page 80