5-9
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Routing Mode Procedures
Step 2
To check whether this feature is enabled, enter:
show dhcp server pool 0
Step 3
Enable NAT:
set nat enabled
Step 4
Reboot the Cisco 67x:
reboot
Step 5
To check whether NAT is enabled, enter:
show nat
Step 6
Write the changes to NVRAM:
write
Step 7
Reboot the Cisco 67x:
reboot
When the Cisco 67x reboots, PPP routing is enabled.
Disabling PPP Routing
Complete the following steps to disable the PPP routing feature for the Cisco 67x.
You must be in the
enable
mode.
Step 1
Disable the DHCP server:
set dhcp server disabled
Step 2
Disable NAT:
set nat disabled
Step 3
Write the changes to NVRAM:
write
Comments to this Manuals