Cisco Catalyst 8540 MSR Technical Information download pdf (Page 38)

Chapter 3 Initially Configuring the ATM Switch Router

Testing the Configuration

3-38

ATM Switch Router Software Configuration Guide

78-6277-03, Cisco IOS Release 12.0(13)W5(19)

Confirming the ATM Connections

Use the ping atm interface command to confirm that the ATM connections are configured correctly:

Switch# ping atm interface atm 3/0/0 0 5 seg-loopback

Type escape sequence to abort.

Sending Seg-Loopback 5, 53-byte OAM Echoes to a neighbour,timeout is 5 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms

Switch#

Confirming the ATM Interface Configuration

Use the show atm interface command to confirm the ATM interfaces are configured correctly:

Switch# show atm interface atm 1/0/0

Interface: ATM1/0/0 Port-type: oc3suni

IF Status: UP Admin Status: up

Auto-config: disabled AutoCfgState: not applicable

IF-Side: Network IF-type: NNI

Uni-type: not applicable Uni-version: not applicable

Max-VPI-bits: 8 Max-VCI-bits: 14

Max-VP: 255 Max-VC: 16383

ConfMaxSvpcVpi: 255 CurrMaxSvpcVpi: 255

ConfMaxSvccVpi: 255 CurrMaxSvccVpi: 255

ConfMinSvccVci: 35 CurrMinSvccVci: 35

Svc Upc Intent: pass Signalling: Enabled

ATM Address for Soft VC: 47.0091.8100.0000.00e0.4fac.b401.4000.0c80.8000.00

Configured virtual links:

PVCLs SoftVCLs SVCLs TVCLs PVPLs SoftVPLs SVPLs Total-Cfgd Inst-Conns

4 0 0 0 1 0 0 5 3

Logical ports(VP-tunnels): 1

Input cells: 263109 Output cells: 268993

5 minute input rate: 0 bits/sec, 0 cells/sec

5 minute output rate: 1000 bits/sec, 2 cells/sec

Input AAL5 pkts: 171788, Output AAL5 pkts: 174718, AAL5 crc errors: 0

Cisco Catalyst 8540 MSR Technical Information Page 38