Cisco Catalyst 8540 MSR Technical Information download pdf (Page 7)

Chapter 3 Initially Configuring the ATM Switch Router

Configuring the IP Interface

3-7

ATM Switch Router Software Configuration Guide

78-6277-03, Cisco IOS Release 12.0(13)W5(19)

To display the physical interface configuration, use the following privileged EXEC commands:

Examples

The following example demonstrates using the show controllers command to display the OC-3c

physical interface configuration after modification of the defaults:

Switch# show controllers atm 0/0/0

IF Name: ATM0/0/0 Chip Base Address: A8808000

Port type: 155UTP Port rate: 155 Mbps Port medium: UTP

Port status:SECTION LOS Loopback:None Flags:8300

TX Led: Traffic Pattern RX Led: Traffic Pattern TX clock source: network-derived

Framing mode: stm-1

Cell payload scrambling off

Sts-stream scrambling off

The following example displays the OC-3c physical layer scrambling configuration after modification

of the defaults using the more system:running-config command:

Switch# more system:running-config

version XX.X

interface ATM0/0/0

no keepalive

atm manual-well-known-vc

atm access-group tod1 in

atm pvc 0 35 rx-cttr 3 tx-cttr 3 interface ATM0 0 any-vci encap qsaal

sonet stm-1

no scrambling sts-stream

no scrambling cell-payload

Configuring the IP Interface

IP addresses can be configured on the multiservice route processor interfaces. Each IP address is

configured for one of the following types of connections:

• Ethernet port—Can be configured either from the BOOTP server or by using the ip address

command in interface configuration mode.

• Classical IP over ATM—See Chapter 12, “Configuring IP over ATM.”

• LANE client—See Chapter 13, “Configuring LAN Emulation.”

• Serial Line Internet Protocol/Point-to-Point Protocol (SLIP/PPP)—See the Dial Solutions

Configuration Guide.

Command Purpose

show controllers atm card/subcard/port Shows the physical layer configuration.

more system:running-config Shows the physical layer scrambling

configuration.

1 2 3 4 5 6 7 8 ... 42

No comments

Cisco Catalyst 8540 MSR Technical Information Page 7