Cisco IAD2435-8FXS Specifications download pdf (Page 24)

2-4

Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide

OL-4306-03

Chapter 2 Using the setup Command Facility

Configuring Global Parameters

Step 2 When the following message appears, enter yes to begin the initial configuration dialog:

Would you like to enter the initial configuration dialog? [yes/no]:

Note If you answer no to this message, you are prompted to terminate AutoInstall. AutoInstall is a

procedure that configures a new Cisco IAD based on the configuration of an existing

Cisco IAD.

If you terminate AutoInstall, you enter the Cisco IOS software CLI.

Note The number of interfaces shown depends on the Cisco IAD2430 series model.

Step 3 When the following message appears, press Enter to see the current interface summary:

First, would you like to see the current interface summary? [yes]:

Any interface listed with OK? value “NO” does not have a valid configuration

Interface IP-Address OK? Method Status Protocol

FastEthernet0/0 unassigned NO unset up up

FastEthernet0/1 unassigned NO unset up down

Step 4 Enter a hostname for the Cisco IAD:

Configuring global parameters:

Enter hostname [Router]: IAD2435

The enable secret is a password used to protect access to privileged EXEC and

configuration modes. This password, after entered, becomes encrypted in the configuration.

Step 5 Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when

viewing the configuration:

Enter enable secret:

xxxx

The enable password is used when you do not specify an enable secret password, with some

older software versions, and some boot images.

Step 6 Enter an enable password that is different from the enable secret password. This password is not

encrypted (less secure) and can be seen when viewing the configuration:

Enter enable password:

guessme

The virtual terminal password is used to protect access to the router over a network

interface.

Step 7 Enter the virtual terminal password, which prevents unauthenticated access to the router through ports

other than the console port:

Enter virtual terminal password:

guessagain

Step 8 Respond to the following prompts as appropriate for your network:

Configure SNMP Network Management? [yes]: n

Configure bridging? [no]:

Configure IP? [yes]:

Configure RIP routing? [yes]: n

Configure CLNS? [no]:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 123 124

Comments to this Manuals

No comments

Cisco IAD2435-8FXS Specifications Page 24

Comments to this Manuals

Related products and manuals for Networking Cisco IAD2435-8FXS