Cisco IAD2435-8FXS Specifications Page 66

  • Download
  • Add to my manuals
  • Print
  • Page
    / 124
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 65
3-32
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
Chapter 3 Configuring with the Command-Line Interface
Configuring 1-Port ADSL/SHDSL WAN Interface Card
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router#
Configuring 1-Port ADSL/SHDSL WAN Interface Card
The ADSL/SHDSL WAN interface card is a 1-port WAN interface card (WIC) for the Cisco IAD2430
Series IADs. The card provides asymmetric digital subscriber line (ADSL) or symmetric high bit-rate
digital subscriber line (SHDSL) high-speed digital data transfer between a single customer premises
equipment (CPE) subscriber and the central office.
Note The Cisco IAD2435 router is a fixed-configuration router and does not support interface cards.
Note ADSL/SHDSL is a last-mile access technology, which has an asymmetrical data rate running over a
single copper wire pair.
Note A 1-port ADSL/SHDSL WIC must be installed in the router to match the DSL service to be configured.
Configuration Tasks
See the following sections for configuration tasks for this feature. Each task in the list is identified as
either required or optional:
Configuring the ADSL/SHDSL Port on the ADSL and SHDSL WAN Interface Card (required)
Verifying ATM Configuration (optional)
Features used on the ADSL/SHDSL WAN interface card must also be configured on the digital
subscriber line access multiplexer (DSLAM). See the documentation for the specific DSLAM for
information about configuring features.
Configuring the ADSL/SHDSL Port on the ADSL and SHDSL WAN Interface Card
Perform the following steps to configure an ADSL/SHDSL port on the ADSL/SHDSL WAN interface
card.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface atm slot/port
4. ip address ip address subnet mask
5. pvc name vpi/vci
Page view 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 123 124

Comments to this Manuals

No comments