Cisco IAD2435-8FXS Specifications download pdf (Page 44)

3-10

Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide

OL-4306-03

Chapter 3 Configuring with the Command-Line Interface

Configuring T1/E1 Interfaces

Configuring Channel Groups on T1/E1 to Support Data Under SHDSL Controller

To support data under symmetric high bit-rate digital subscriber line (SHDSL) controller, use the

following procedure either to configure a new T1/E1 interface for channelized T1/E1 (CT1) or PRI or

to change the configuration of an existing interface.

Perform the following steps to configure channel groups on T1/E1 to support data under SHDSL

controller.

SUMMARY STEPS

1. enable

2. configure terminal

3. ip routing

4. controller dsl slot/port

5. mode {atm|t1|e1)

6. controller t1 slot/port

7. channel-group channel-group-number timeslots range

8. interface type number

9. ip address ip address subnet mask

10. exit

11. Ctrl-z

DETAILED STEPS

Command or Action Purpose

Step 1

enable

Example:

Router# enable

Enters privileged EXEC mode.

Step 2

configure terminal

Example:

Router# configure terminal

Enters global configuration mode.

Step 3

ip routing

Example:

Router(config)# ip routing

Enables routing protocols as required for your global

configuration. This example uses IP routing.

Step 4

controller dsl

slot/port

Example:

Router(config)# controller dsl 2/4

Selects the DSL interface to configure. Controller

numbers vary. See

Port Numbering Conventions,

page 1-5.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 123 124

Comments to this Manuals

No comments

Cisco IAD2435-8FXS Specifications Page 44

Comments to this Manuals

Related products and manuals for Networking Cisco IAD2435-8FXS