Cisco IAD2435-8FXS Specifications download pdf (Page 46)

3-12

Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide

OL-4306-03

Chapter 3 Configuring with the Command-Line Interface

Configuring T1/E1 Interfaces

Configuring Switch Types for ISDN PRI Q.931 Support

Perform the following steps to configure Q Signalling (QSIG) signaling support on Cisco IAD2430

series IADs.

SUMMARY STEPS

1. enable

2. configure terminal

3. isdn switch-type primary

4. controller t1/e1 slot/port

5. pri-group timeslots range

6. isdn protocol-emulate {user|network}

7. no line-power

8. isdn incoming-voice voice

9. exit

10. Ctrl-z

DETAILED STEPS

Command or Action Purpose

Step 1

enable

Example:

Router# enable

Enters privileged EXEC mode.

Step 2

configure terminal

Example:

Router# configure terminal

Enters global configuration mode.

Step 3

isdn switch-type primary

Example:

Router(config)# isdn switch-type primary-net5

(Optional; see note.) Selects a service provider switch

type that accommodates PRI.

Note You can configure the ISDN switch type in either

global or interface configuration mode.

If you configure the switch type here, specify the switch

type for all PRI ports.

If you configure the switch type on a single interface,

specify the switch type for that interface. The switch type

specified for any individual interface overrides the

globally specified switch type.

Step 4

controller t1/e1

slot/port

Example:

Router(config)# controller t1 0/2

Enters controller configuration mode for the controller at

the specified slot/port location. Valid values for slot and

port are 0 and 1.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 123 124

Comments to this Manuals

No comments

Cisco IAD2435-8FXS Specifications Page 46

Comments to this Manuals

Related products and manuals for Networking Cisco IAD2435-8FXS