Cisco 7304 Installation Guide download pdf (Page 36)

3-12

Cisco 7304 Router Modular Services Card and Shared Port Adapter Hardware Installation Guide

OL-4681-01

Chapter 3 Overview: Cisco 7304 Router Shared Port Adapters

OC-3 POS SPA Overview

Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])

and is mapped into the STS-3c/STM-1 frame.

The 2-Port and 4-Port OC-3c/STM-1 POS SPA interface is compliant with the following RFCs:

• RFC 1619, PPP over SONET/SDH

• RFC 1662, PPP in HDLC-like Framing

The 2-Port and 4-Port OC-3c/STM-1 POS SPA also provides support for SNMP agent v1

(RFC 1155–1157) and RFC 1213:

• RFC 1155, Structure and Identification of Management Information for TCP/IP-based Internets

• RFC 1156, Management Information Base for Network Management of TCP/IP-Based Internets

• RFC 1157, Simple Network Management Protocol (SNMP)

• RFC 1213, Management Information Base (MIB) for Network Management of TCP/IP-Based

Internets:MIB II.

2-Port and 4-Port OC-3c/STM-1 POS SPA Optical Transceiver Modules and

Cables

The 2-Port and 4-Port OC-3c/STM-1 POS SPA uses a small form-factor pluggable (SFP) optical

transceiver module installed in each port for SONET and SDH single-mode and multimode optical fiber

connection (See Figure 3-9).

Cisco Systems qualifies the optics that are approved for use with its SPAs. The 2-Port and 4-Port

OC-3c/STM-1 POS SPA supports the following types of optical transceiver modules:

• Multimode (MM) SFP module—SFP-OC3-MM

• Short reach (SR) SFP module—SFP-OC3-SR

• Intermediate reach (IR) SFP module (15 km)—SFP-OC3-IR1

• Long reach (LR) SFP module (40 km)—SFP-OC3-LR1

• LR SFP module (80 km)—SFP-OC3-LR2

Figure 3-9 SFP Optics Module

127158

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 83 84

No comments

Cisco 7304 Installation Guide Page 36