Cisco IAD2435-8FXS Specifications download pdf (Page 50)

3-16

Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide

OL-4306-03

Chapter 3 Configuring with the Command-Line Interface

Configuring T1/E1 Interfaces

Example

The following example shows typical DS0 groups configuration:

controller T1 0/0

channel-group 0 timeslots 1-20 speed 64

ds0-group 1 timeslots 21-24 type fxo-loopstart

voice-port 0/0:1

voice-port 0/1/0 << FXS

dial-peer voice 1 pots

description calls to PSTN - dial 9 from FXS

destination-pattern 9T

port 0/0:1

dial-peer voice 2 pots

description calls to Analog phone from PSTN

destination-pattern 4083333333

port 0/1/0

Configuring TDM Cross-Connect

For multiflex trunk interfaces using the time-division multiplexing (TDM) connect function, you can use

the connect command to cross-connect (1) two TDM groups from two controllers, or (2) an analog FXS

port and a DS0 group on a T1. Cross-connecting is done differently for data and voice, as shown in the

following procedures:

• Configuring TDM to TDM

• Configuring TDM to Analog Voice Port

Step 12

exit

Example:

Router(config-if)# exit

Exits to global configuration mode.

Step 13

Ctrl-z

Example:

Router#

Returns to enable mode when you finish configuring

interfaces.

Command or Action Purpose

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 123 124

No comments

Cisco IAD2435-8FXS Specifications Page 50