Cisco RVS4000 - Gigabit Security Router User's Guide download pdf (Page 36)

Chapter 5

Setting Up and Configuring the Router

4-Port Gigabit Security Router with VPN

L2 > VLAN Port Setting

L2 Switch > VLAN Port Setting

Port ID Displays the port number from 1 to 4.

Mode Select the mode of the port, either Trunk,

Untagged, or Tagged. The default is Untagged. In Trunk

mode, incoming and outgoing frames can be either

tagged or untagged; incoming untagged frames are

tagged with the default PVID (Port VLAN ID). In Untagged

mode, all incoming and outgoing frames are untagged. In

Tagged mode, all incoming and outgoing frames must be

tagged; all untagged frames are dropped.

PVID The Port VLAN ID (PVID) assigned to untagged

frames received on the interface. The default is 1. If the

Mode is Tagged, the port will receive only tagged frames

and so the port will have no PVID.

L2 > VLAN Membership

L2 Switch > VLAN Membership

VLAN ID Select the VLAN whose membership you want

to configure.

Description Enter a VLAN group name of up to 50

characters.

Function/Port table The top half of the table indicates

each port’s current mode (Untagged, Tagged, or Trunk). The

lower half of the table is used to assign port membership

for the selected VLAN. The default for each port is Exclude

(the port is not a member of the VLAN). To make a port a

member of the VLAN, select the applicable mode(s). For

example, if the port mode is Untagged, select Untagged;

if the mode is Tagged, select Tagged; if the mode is Trunk,

select either Tagged or Untagged.

L2 > RADIUS

L2 Switch > RADIUS

Mode Select Enabled or Disabled from the drop-down

menu to enable or disable RADIUS.

RADIUS IP Enter the Server IP address.

RADIUS UDP Port Enter the UDP port. The UDP port is

used to verify the RADIUS server authentication.

RADIUS Secret Enter the Key string used for authenticating

and encrypting all RADIUS communications between the

device and the RADIUS server. This key must match the

RADIUS server encryption key. If no host-specific value is

specified, the global value applies to each host.

Administration State Specifies the port authorization

state. The possible field values are:

Auto • The controlled port state is set by the

Authentication method.

Force Authorized • The controlled port state is set to

Force-Authorized (forward traffic).

Force Unauthorized • The controlled port state is set

to Force-Unauthorized (discard traffic).

Port State Displays the state of the selected port.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 82 83

Comments to this Manuals

No comments

Cisco RVS4000 - Gigabit Security Router User's Guide Page 36

Comments to this Manuals

Related products and manuals for Networking Cisco RVS4000 - Gigabit Security Router