Cisco 7961 User's Guide download pdf (Page 8)

Connecting Your Phone

IMT will likely initially connect your new Cisco Unified IP Phone to the APU IP telephony network. If

your phone needs to be moved for any reason, refer to the figure and table below to connect your

phone.

DC adaptor port (DC48V) – Not used

Access port (10/100 PC) – Plug into

computer data port

AC-to-DC power supply – Not used

Handset port

AC power cord – Not used

Headset port

Network port (10/100 SW) – Plug into data jack

Footstand button

Connecting Your Phone

Your Cisco phone is powered by and runs off of a data connection. Your phone should be plugged

into a data jack (see 4 above), NOT a phone jack. Your computer can then run off of the data

connection through the phone by plugging your computer into the phone (see 5 above).

Adjusting the Footstand

To change the angle that your phone sits on your desk, adjust the footstand while pressing the

footstand button.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

No comments

Cisco 7961 User's Guide Page 8