Cisco WIRELESS LAN CONTROLLER OL-17037-01 User Manual download pdf (Page 38)

7-38

Cisco Wireless LAN Controller Configuration Guide

OL-17037-01

Chapter 7 Controlling Lightweight Access Points

Cisco Workgroup Bridges

• These features are not supported for wired clients connected to a WGB:

–

MAC filtering

–

Link tests

–

Idle timeout

• To enable the WGB to communicate with the lightweight access point, create a WLAN and make

sure that Aironet IE is enabled.

Sample WGB Configuration

Here is a sample configuration of a WGB access point using static WEP with a 40-bit WEP key:

ap#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

ap(config)#dot11 ssid WGB_with_static_WEP

ap(config-ssid)#authentication open

ap(config-ssid)#guest-mode

ap(config-ssid)#exit

ap(config)#interface dot11Radio 0

ap(config)#station-role workgroup-bridge

ap(config-if)#encry mode wep 40

ap(config-if)#encry key 1 size 40 0 1234567890

ap(config-if)#WGB_with_static_WEP

ap(config-if)#end

To verify that the WGB is associated to an access point, enter this command on the WGB:

show dot11 association

Information similar to the following appears:

ap#show dot11 associations

802.11 Client Stations on Dot11Radio0:

SSID [FCVTESTING] :

MAC Address IP address Device Name Parent State

000b.8581.6aee 10.11.12.1 WGB-client map1 - Assoc

ap#

Using the GUI to View the Status of Workgroup Bridges

Follow these steps to view the status of WGBs on your network using the controller GUI.

Step 1 Click Monitor > Clients to open the Clients page (see Figure 7-10).

1 ... 37 38 39 ... 80

No comments

Cisco WIRELESS LAN CONTROLLER OL-17037-01 User Manual Page 38