Cisco WIRELESS LAN CONTROLLER OL-17037-01 User Manual download pdf (Page 58)

7-58

Cisco Wireless LAN Controller Configuration Guide

OL-17037-01

Chapter 7 Controlling Lightweight Access Points

Migrating Access Points from the -J Regulatory Domain to the -U Regulatory Domain

Step 5 Enter this command to migrate the access points from the -J regulatory domain to the -U regulatory

domain:

config ap migrate j52w52 {all | ap_name}

Information similar to the following appears:

Migrate APs with 802.11A Radios in the “J” Regulatory Domain to the “U” Regulatory Domain.

The “J” domain allows J52 frequencies, the “U” domain allows W52 frequencies.

WARNING: This migration is permanent and is not reversible, as required by law.

WARNING: Once migrated the 802.11A radios will not operate with previous OS versions.

WARNING: All attached “J” radios will be migrated.

WARNING: All migrated APs will reboot.

WARNING: All migrated APs must be promptly reported to the manufacturer.

Send the AP list and your company name to: [email protected]

This AP is eligible for migration:

00:14:1c:ed:27:fe AIR-AP1242AG-J-K9ap1240

Begin to migrate Access Points from “J”(J52) to “U”(W52). Are you sure? (y/n)

Step 6 Enter Y when prompted to confirm your decision to migrate.

Step 7 Wait for all access points to reboot and rejoin the controller. This process may take up to 15 minutes,

depending on access point. The AP1130, AP1200, and AP1240 reboot twice; all other access points

reboot once.

Step 8 Enter this command to verify migration for all access points:

show ap migrate

Information similar to the following appears:

No APs are eligible for migration.

These 1 APs have already been migrated:

00:14:1c:ed:27:fe AIR-AP1242AG-J-K9ap1240 “U”Reg. Domain

Step 9 Enter these commands to re-enable the 802.11a and 802.11b/g networks:

config 802.11a enable network

config 802.11b enable network

Step 10 Send an e-mail with your company name and the list of access points that have been migrated to

[email protected]m. We recommend that you cut and paste the output from the show ap

migrate command in Step 8 into this e-mail.

1 ... 57 58 59 ... 80

No comments

Cisco WIRELESS LAN CONTROLLER OL-17037-01 User Manual Page 58