Cisco VPN 3000 User's Guide Page 121

  • Download
  • Add to my manuals
  • Print
  • Page
    / 502
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 120
Configuration | System | Address Management | Pools
6-3
VPN 3000 Concentrator Series User Guide
Use Address Pools
Check this box to have the VPN Concentrator assign IP addresses from an internally configured pool.
If you use this method, configure the IP address pools on the
Configuration | System | Address Management
| Pools
screens below.
Apply / Cancel
To include your settings in the active configuration, click Apply. The Manager returns to the Configuration
| Address Management
screen.
Reminder: To save the active configuration and make it the boot configuration, click the
Save Needed icon at the
top of the Manager window.
To discard your settings or changes, click
Cancel. The Manager returns to the Configuration | Address
Management
screen.
Configuration | System | Address Management | Pools
This section of the Manager lets you configure IP address pools from which the VPN Concentrator
assigns addresses to clients. If you check
Use Address Pools on the Configuration | System | Address
Management | Assignment
screen above, you must configure at least one address pool. The IP addresses
in the pools must not be assigned to other network resources.
Figure 6-3: Configuration | System | Address Management | Pools screen
IP Pool Entry
The IP Pool Entry list shows each configured address pool as an address range; e.g., 10.10.147.100 -
10.10.147.177
. If no pools have been configured, the list shows --Empty--. The pools are listed in the
order they are configured. The system uses these pools in the order listed: if all addresses in the first pool
have been assigned, it uses the next pool, and so on.
Page view 120
1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 501 502

Comments to this Manuals

No comments