Cisco RV016 - Small Business - 10/100 VPN Router User's Guide download pdf (Page 72)

Chapter 6: Setting up and Configuring the Router

VPN Tab - Client to Gateway

10/100 16-Port VPN Router

IP + Domain Name(FQDN) Authentication. If you select this type, enter the FQDN (Fully Qualified Domain

Name) in the Domain Name field, and an IP address will automatically appear in the IP address field. The

FQDN is the host name and domain name for a specific computer on the Internet. An example of a FQDN is

vpn.myvpnserver.com. The FQDN and IP address must match the FQDN and IP address of the Remote Client at

the other end of the tunnel. The FQDN and IP can be used for only one tunnel connection.

IP + E-mail Addr.(USER FQDN) Authentication. If you select this type, enter the appropriate e-mail address in

the E-mail address fields, and an IP address will automatically appear in the IP address field.

Dynamic IP + Domain Name(FQDN) Authentication. If the Local Security Gateway has a dynamic IP and you

want to use the Domain Name for authentication, then select this type. When the Remote Client asks to create

a tunnel with the Router, the Router will work as a responder. For authentication, complete the Domain Name

field, and make sure it matches the Domain Name set on the Remote Client. The Domain Name can be used

for only one tunnel connection, so you can’t use the same Domain Name to create another new tunnel

connection.

Dynamic IP + E-mail Addr.(USER FQDN) Authentication. If the Local Security Gateway has a dynamic IP and

you want to use the e-mail address for authentication, then select this type. When the Remote Client asks to

create a tunnel with the Router, the Router will work as a responder. For authentication, enter the appropriate

e-mail address in the E-mail address fields.

Local Security Group Type

Select the local LAN user(s) behind the Router that can use this VPN tunnel. Select one of these three available

types: IP, Subnet, or IP Range. The Local Security Group Type you select should match the Remote Security

Group Type selected on the remote VPN client(s) at the other end of the tunnel(s).

After you have selected the Local Security Group Type, the settings available on this screen may change,

depending on which selection you have made.

IP. If you select IP Only, then only the computer with a specific IP address will be able to access the tunnel.

Enter the appropriate IP address. The default IP is 192.168.1.0.

Subnet. If you select Subnet, which is the default, then all computers on the local subnet will be able to

access the tunnel. Complete the IP address and Subnet Mask fields. The default IP is 192.168.1.0, and the

default Subnet Mask is 255.255.255.0.

IP Range. If you select IP Range, then you can specify a range of IP addresses within the subnet that will be

able to access the tunnel. Complete the IP range fields. The default IP Range is 192.168.1.0~254.

Figure 6-77: Local Security Group Type - IP

Figure 6-78: Local Security Group Type - Subnet

Figure 6-79: Local Security Group Type - IP Range

Figure 6-75: Local Security Gateway Type -

Dynamic IP + Domain Name (FQDN) Authentication

Figure 6-74: Local Security Gateway Type -

IP + E-mail Addr. (USER FQDN) Authentication

Figure 6-76: Local Security Gateway Type -

Dynamic IP + E-mail Addr. (USER FQDN) Authentication

1 ... 71 72 73 ... 127

No comments

Cisco RV016 - Small Business - 10/100 VPN Router User's Guide Page 72