Cisco RV016 - Small Business - 10/100 VPN Router User's Guide download pdf (Page 97)

Appendix A: Troubleshooting

Common Problems and Solutions

10/100 16-Port VPN Router

D. In the command prompt, type ping followed by your Internet IP address and press the Enter key. The

Internet IP Address can be found in the web interface of the Router. For example, if your Internet IP

address is 1.2.3.4, you would enter ping 1.2.3.4 and press the Enter key.

• If you get a reply, the computer is connected to the Router.

• If you do NOT get a reply, try the ping command from a different computer to verify that your original

computer is not the cause of the problem.

E. In the command prompt, type ping www.linksys.com and press the Enter key.

• If you get a reply, the computer is connected to the Internet. If you cannot open a webpage, try the

ping command from a different computer to verify that your original computer is not the cause of the

problem.

• If you do NOT get a reply, there may be a problem with the connection. Try the ping command from a

different computer to verify that your original computer is not the cause of the problem.

6. I am not getting an IP address on the Internet with my Internet connection.

A. Refer to “Problem #2, I want to test my Internet connection” to verify that you have connectivity.

B. If you need to register the MAC address of your Ethernet adapter with your ISP, please see “Appendix C:

Finding the MAC Address and IP Address for Your Ethernet Adapter.” If you need to clone the MAC address

of your Ethernet adapter onto the Router, see the MAC Address Clone section of “Chapter 6: Setting up

and Configuring the Router” for details.

C. Make sure you are using the right Internet settings. Contact your ISP to see if your Internet connection

type is DHCP, Static IP Address, or PPPoE (commonly used by DSL consumers). Please refer to the Setup

section of “Chapter 6: Setting up and Configuring the Router” for details on Internet Connection Type

settings.

D. Make sure you use the right cable. Check to see if the Internet LED is solidly lit.

E. Make sure the cable connecting from your cable or DSL modem is connected to the Router’s Internet port.

Verify that the Status page of the Router’s Web-based Utility shows a valid IP address from your ISP.

F. Turn off the computer, Router, and cable/DSL modem. Wait 30 seconds, and then turn on the Router,

cable/DSL modem, and computer. Check the Status tab of the Router’s Web-based Utility to see if you get

an IP address.

7. I am not able to access the Router’s Web-based Utility Setup page.

A. Refer to “Problem #2, I want to test my Internet connection” to verify that your computer is properly

connected to the Router.

B. Refer to “Appendix C: Finding the MAC Address and IP Address for Your Ethernet Adapter” to verify that

your computer has an IP Address, Subnet Mask, Gateway, and DNS.

C. Set a static IP address on your system; refer to “Problem #1: I need to set a static IP address.”

D. Refer to “Problem #10: I need to remove the proxy settings or the dial-up pop-up window (for PPPoE

users).”

1 ... 96 97 98 ... 127

No comments

Cisco RV016 - Small Business - 10/100 VPN Router User's Guide Page 97