Cisco RVS4000 - Gigabit Security Router User's Guide download pdf (Page 60)

Gateway-to-Gateway VPN Tunnel

4-Port Gigabit Security Router with VPN

Appendix D

For the VPN Tunnel setting, select 6. Enable.

The WAN IP address (B.B.B.B) of the RV082 will be 7.

automatically detected.

For the Local Security Group Type, select Subnet. Enter

the RV082’s local network settings in the IP Address and

Subnet Mask fields.

RV082 VPN Settings

For the Remote Security Gateway Type, select 8. IP

address. Enter the RVS4000’s WAN IP address in the IP

Address field.

For the Remote Security Group Type, select 9. Subnet.

Enter the RVS4000’s local network settings in the IP

Address and Subnet Mask fields.

In the IPSec Setup section, select the appropriate 10.

encryption, authentication, and other key management

settings. (These should match the settings of the

RVS4000.)

In the 11. Preshared Key field, enter a string for this key, for

example, 13572468.

RV082 IPSec Setup Settings

If you need more detailed settings, click 12. Advanced

Settings. Otherwise, click Save Settings.

Configuration of PC 1 and PC 2

Verify that PC 1 and PC 2 can ping each other (refer to

Windows Help for more information). If the computers

can ping each other, then you know the VPN tunnel is

configured correctly.

Configuration when Both Gateways Use

Dynamic IP Addresses

This example assumes both Gateways are using dynamic

IP addresses. If only the Remote Gateway uses a dynamic

IP address, refer to “Configuration when the Remote

Gateway Uses a Dynamic IP.”

RVS4000

Dynamic IP: A.A.A.A with

Domain Name: www.xyz.com

LAN: 192.168.5.1

RV082

Dynamic IP: B.B.B.B with

Domain Name: www.abc.com

LAN: 192.168.1.1

Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using

Dynamic IP

NOTE: Each computer must have a network

adapter installed.

Configuration of the RVS4000

Follow these instructions for the first VPN Router,

designated RVS4000. The other VPN Router is designated

the RV082.

Launch the web browser for a networked computer, 1.

designated PC 1.

Access the web-based utility of the RVS4000. (Refer to 2.

“Chapter 5: Setting Up and Configuring the Router” for

details.)

Click the3. VPN tab.

Click 4. IPSec VPN.

Enter a name in the 5. Tunnel Name field.

For the IPSec VPN Tunnel setting, select 6. Enable.

The WAN IP address (A.A.A.A) of the RVS4000 will be 7.

automatically detected.

For the Local Security Group Type, select Subnet. Enter

the RVS4000’s local network settings in the IP Address

and Subnet Mask fields.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 82 83

Comments to this Manuals

No comments

Cisco RVS4000 - Gigabit Security Router User's Guide Page 60

Comments to this Manuals

Related products and manuals for Networking Cisco RVS4000 - Gigabit Security Router