Cisco 7304 Installation Guide download pdf (Page 75)

6-7

Cisco 7304 Router Modular Services Card and Shared Port Adapter Hardware Installation Guide

OL-4681-01

Chapter 6 Installing and Removing a Shared Port Adapter

Checking the Installation

Step 1 Use the show c7300 command to display the list of supported hardware in each router slot, including

supported SPAs, SPA type, and SPA status. Ensure that your SPA is listed in the output and that the status

is OK.

Step 2 Use the show version command to display the system hardware configuration. Ensure that the list

includes the new SPAs and the correct interface types.

Step 3 Specify one of the new SPAs with the show interfaces type router-module-slot/subslot/SPA-port-number

command and verify that the first line of the display specifies the SPA with the correct slot number. Also

verify that the SPA and line protocol are in the correct state: up or down.

Step 4 Display the protocols configured for the entire system and specific SPAs with the show protocols

command. If necessary, return to configuration mode to add or remove protocol routing on the system

or specific SPAs.

Step 5 Display the running configuration file with the show running-config command. Verify that the

configuration is accurate for the system and each SPA.

Step 6 Display the SPA FPD image version and the required image version using the show hw-module subslot

fpd command. An FPD incompatibility can disable a SPA, so this command is useful for verifying that

the FPD image on the SPA is compatible with the running Cisco IOS release.

If the SPA is down and you configured it as up, or if the displays indicate that the hardware is not

functioning properly, ensure that the network interface is properly connected. If you still have problems

bringing the SPA up, contact a service representative for assistance.

Using show Commands to Display SPA Information

Table 6-1 describes the show commands you can use to display SPA information.

Table 6-1 show Commands to Display SPA Information

Command Type of Information Provided

show running-config The router’s running configuration and interfaces available in the

system.

show hw-module subslot oir The operational status of all SPAs in the system.

show controllers General hardware information about a particular SPA, MSC, or all

hardware in the system.

show diag SPA type in that slot, number of ports, hardware revision, part

number, FPGA, and EEPROM contents.

show hw-module subslot fpd FPD version information of SPAs in the system.

show version Cisco IOS software version, names and sources of configuration

files, and boot images.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 83 84

No comments

Cisco 7304 Installation Guide Page 75