Cisco 2955 Installation Guide download pdf (Page 44)

Chapter 1 Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

1-10

Catalyst 2955 Hardware Installation Guide

78-14944-03

end

Step 10 These choices appear:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots,

save it in nonvolatile RAM (NVRAM) by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

After you complete the setup program, the switch can run the default

configuration that you created. If you want to change this configuration or want

to perform other management tasks, use one of these tools:

• Command-line interface (CLI)

• Network Assistant (for one or more switches)

To use the CLI, enter commands at the Switch> prompt through the console port

by using a terminal-emulation program or through the network by using Telnet.

For configuration information, see the switch software configuration guide or the

switch command reference.

To use the Network Assistant, see the Getting Started with Cisco Network

Assistant guide on Cisco.com.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 297 298

No comments

Cisco 2955 Installation Guide Page 44