Cisco 600W Installation Guide download pdf (Page 23)

CHAPTER

Installing the Cisco RPS 2-1

Installing the Cisco RPS

You can set the Cisco RPS chassis on a desktop or install it in a rack.

Warning Only trained and qualiﬁed personnel should be allowed to install or replace this

equipment.

Warning Do not work on the system or connect or disconnect cables during periods of

lightning activity.

Warning Before opening the chassis, disconnect the telephone-network cables to avoid

contact with telephone-network voltages.

Warning This equipment is intended to be grounded. Ensure that the host is connected to

earth ground during normal use.

Warning Never defeat the ground conductor or operate the equipment in the absence of a

suitably installed ground conductor. Contact the appropriate electrical inspection authority

or an electrician if you are uncertain that suitable grounding is available.

Warning When installing the unit, the ground connection must always be made ﬁrst and

disconnected last.

• Do not work alone if potentially hazardous conditions exist.

• Never assume that power is disconnected from a circuit. Always check.

rps2 Page 1 Monday, September 14, 1998 8:17 AM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

No comments

Cisco 600W Installation Guide Page 23