Cisco 600W Installation Guide download pdf (Page 45)

Connecting Cables 4-9

Connecting Hubs

Step 7 Power ON the Cisco RPS. There is one power switch for each AC input power

module. Make sure the power switch is ON (|) for each AC power module used.

(See Figure 4-7.)

Figure 4-7 Powering ON the Cisco RPS

The Cisco RPS provides power in 10 to 15 seconds. The Cisco RPS is working

properly when all its front-panel LEDs are solid green. If the external device

does not power up, refer to Appendix B, “Troubleshooting the Cisco RPS.”

Step 8 If you are using the redundant-with-reboot conﬁguration, press the power switch

on the hub to the ON (|) position to begin providing power simultaneously with

the Cisco RPS.

H9700

rps4 Page 9 Monday, September 14, 1998 8:19 AM

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 75 76

No comments

Cisco 600W Installation Guide Page 45