2-6
Rack-Mounting the Cisco RPS
Cisco Redundant Power System Hardware Installation Guide
Attaching Brackets
To install the Cisco RPS in a rack, attach the brackets in one of the following ways:
• With the Cisco RPS front panel forward (see Figure 2-3).
• With the Cisco RPS rear panel forward (see Figure 2-4).
• In a center-mount telco rack (see Figure 2-5).
Note Although the figures show 19-inch brackets, the procedure is the same for 23-inch,
24-inch, and telco brackets.
Figure 2-3 Bracket Installation—RPS Front Panel Forward
H9696
Note: The second bracket attaches to the other side of the chassis.
FAN
TEMP
rps2 Page 6 Monday, September 14, 1998 8:17 AM
Comments to this Manuals