Cisco 600W Installation Guide download pdf (Page 66)

Cisco Redundant Power System Hardware Installation Guide

Displaying Status

B-4

Displaying Status

Cisco IOS Release 11.2(7)P and later releases support status messages for Cisco 3600

series routers using the Cisco RPS. Cisco IOS Release 11.3(2) and later releases support

status messages for Cisco 2600 series routers using the Cisco RPS. Status messages are not

supported for the FastHub series 100, FastHub series 200, FastHub series 300 100BaseT

hubs, HP 10BaseT Hub-16M 10BaseT hub, the Catalyst 1900 series, Catalyst 2820 series,

Catalyst 2900 series XL switches, Cisco 2500 series and 4000 series routers, and the

Cisco MC3810 multiservice concentrator.

The show env command (available in Cisco IOS Releases 11.2 (7) and later releases)

provides an environmental status of the Cisco RPS. An example display follows:

router# show env

Power Supply:

Redundant Power supply is present.

Thermal status is normal.

AC status is normal.

DC status is normal.

Board Temperature:

Warning: Board overtemperature condition detected.

Caution If the Cisco RPS gets too hot, it shuts down to prevent damage to its components.

If thermal shutdown occurred because the cooling-system failed or ambient temperature

rose above normal operating limits, a thermal warning will display on the router console

and an SNMP trap will be sent before shutdown.

rpsappb Page 4 Monday, September 14, 1998 8:19 AM

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

No comments

Cisco 600W Installation Guide Page 66