Chapter 7. Configuring the Cisco 3012 InfiniBand to Ethernet gateway 145
Example 7-12 is the CLI of the 3012 after creating trunk group TG1 and adding it to bridge
group BG1.
Example 7-12 3012 - after changing to untagged and adding trunk group
3012-1# show config
...
bridge-group 1 subnet-prefix 172.16.225.0 24
bridge-group 1 ib-next-hop 172.16.225.250
bridge-group 1 name "BG1"
!
interface trunk 1
enable
name "TG1"
distribution-type src-mac
!
interface gateway 4/1
bridge-group 1 pkey ff:ff
!
interface Ethernet 4/1
trunk-group 1
!
interface Ethernet 4/2
trunk-group 1
!
interface trunk 1
bridge-group 1
!
Example 7-13 is the CLI of the 4948 after changes to support the aggregation po5.
Example 7-13 4948 - after changes to support aggregation
4848-1#show run
...
interface Port-channel5
switchport
switchport access vlan 88
switchport mode access
...
interface GigabitEthernet1/16
description Connection to 3012 ESM - 4/1 - 4/2 trunk group TG1
switchport access vlan 88
switchport mode access
channel-group 5 mode on
spanning-tree portfast
!
interface GigabitEthernet1/17
description Connection to 3012 ESM - 4/1 - 4/2 trunk group TG1
switchport access vlan 88
switchport mode access
channel-group 5 mode on
spanning-tree portfast
...
interface Vlan88
ip address 172.16.225.250 255.255.255.0
no ip route-cache
...
Comments to this Manuals