Cisco InfiniBand 4x User's Guide download pdf (Page 73)

Chapter 4. Configuring InfiniBand with QLogic bridges 59

20.Restart SRP on the host so that it picks up the new mapping. Check for the remote drives

using the command cat /proc/scsi/scsi. Sample output is shown in Figure 4-34.

Figure 4-34 Remote drives on Linux server

21.On the bridge module web GUI, The green boxes beside the SRP initiator name and the

IOC Map should go from 0 to 1. You might need to click Refresh on the SRP map page.

Figure 4-35 Active direct mapping

We have now created an SRP initiator on the host which is mapped through the bridge

module to the storage device.

Attached devices:

Host: scsi0 Channel: 00 Id: 00 Lun: 00

Vendor: IBM-ESXS Model: ST973401SS Rev: B51C

Type: Direct-Access ANSI SCSI revision: 05

Host: scsi4 Channel: 00 Id: 00 Lun: 00

Vendor: IBM Model: 1722-600 Rev: 0520

Type: Direct-Access ANSI SCSI revision: 03

Host: scsi4 Channel: 00 Id: 00 Lun: 01

Vendor: IBM Model: 1722-600 Rev: 0520

Type: Direct-Access ANSI SCSI revision: 03

Host: scsi5 Channel: 00 Id: 00 Lun: 00

Vendor: IBM Model: 1722-600 Rev: 0520

Type: Direct-Access ANSI SCSI revision: 03

Host: scsi5 Channel: 00 Id: 00 Lun: 01

Vendor: IBM Model: 1722-600 Rev: 0520

Type: Direct-Access ANSI SCSI revision: 03

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 173 174

No comments

Cisco InfiniBand 4x User's Guide Page 73