Cisco InfiniBand 4x User's Guide download pdf (Page 71)

Chapter 4. Configuring InfiniBand with QLogic bridges 57

Figure 4-30 Explicit map configuration

15.Restart SRP on the host so that it picks up the new mapping. Check for the remote drives

using the command cat /proc/scsi/scsi. Figure 4-31 shows sample output.

Figure 4-31 Remote drives on Linux server

16.The boxes beside the SRP initiator name (shown in Figure 4-32 on page 58) and the IOC

Map name indicate the active connections to the virtual HBA. It should go from 0 to 1. You

might need to click Refresh on the SRP map page.

17.Now, you create a direct mapping. Click SRP map config on the GUI main menu page.

Here, you see the virtual HBAs listed:

– If your virtual HBA was created on IOC 1, click the Click To Add link under the IOC 1

heading.

– If your virtual HBA was created on IOC 2, click the Click To Add link under the IOC 2

heading.

18.Give the map a name and select Direct type, then click Next.

Attached devices:

Host: scsi0 Channel: 00 Id: 00 Lun: 00

Vendor: IBM-ESXS Model: ST973401SS Rev: B51C

Type: Direct-Access ANSI SCSI revision: 05

Host: scsi3 Channel: 00 Id: 00 Lun: 00

Vendor: IBM Model: 1722-600 Rev: 0520

Type: Direct-Access ANSI SCSI revision: 03

Host: scsi3 Channel: 00 Id: 00 Lun: 01

Vendor: IBM Model: 1722-600 Rev: 0520

Type: Direct-Access ANSI SCSI revision: 03

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 173 174

No comments

Cisco InfiniBand 4x User's Guide Page 71