Cisco 4G-LTE-ANTM-O-3 Installation Guide download pdf (Page 418)

SHDSL

SHDSL is a technology based on the G.SHDSL (G.991.2) standard that allows both data and voice to be

transmitted over the same line. SHDSL is a packet-based network technology that allows high-speed

transmission over twisted-pair copper wire between a network service provider (NSP) central office and a

customer site, or on local loops created within either a building or a campus.

G.SHDSL devices can extend the reach from central offices and remote terminals to approximately 26,000

feet (7925 m), at symmetrical data rates from 72 kbps up to 2.3 Mbps. In addition, it is repeatable at lower

speeds, which means there is virtually no limit to its reach.

SHDSL technology is symmetric in that it allows equal bandwidth between an NSP central office and a

customer site. This symmetry, combined with always-on access (which eliminates call setup), makes SHDSL

ideal for LAN access.

Network Protocols

Network protocols enable the network to pass data from its source to a specific destination over LAN or WAN

links. Routing address tables are included in the network protocols to provide the best path for moving the

data through the network.

The best-known Transmission Control Protocol/Internet Protocol (TCP/IP) at the internetwork layer is IP,

which provides the basic packet delivery service for all TCP/IP networks. In addition to the physical node

addresses, the IP protocol implements a system of logical host addresses called IP addresses. The IP addresses

are used by the internetwork and higher layers to identify devices and to perform internetwork routing. The

Address Resolution Protocol (ARP) enables IP to identify the physical address that matches a given IP address.

IP is used by all protocols in the layers above and below it to deliver data, which means that all TCP/IP data

flows through IP when it is sent and received regardless of its final destination.

IP is a connectionless protocol, which means that IP does not exchange control information (called a handshake)

to establish an end-to-end connection before transmitting data. In contrast, a connection-oriented protocol

exchanges control information with the remote computer to verify that it is ready to receive data before sending

it. When the handshaking is successful, the computers have established a connection. IP relies on protocols

in other layers to establish the connection if connection-oriented services are required.

Internet Packet Exchange (IPX) exchanges routing information using Routing Information Protocol (RIP), a

dynamic distance-vector routing protocol. RIP is described in more detail in the following sections.

Routing Protocol Options

Routing protocols include the following:

•

Routing Information Protocol (RIP)

•

Enhanced Interior Gateway Routing Protocol (Enhanced IGRP)

The table below shows the difference between RIP and Enhanced IGRP.

Cisco 800 Series Integrated Services Routers Software Configuration Guide

390 OL-31704-02

Concepts

SHDSL

1 2 ... 413 414 415 416 417 418 419 420 421 422 423 ... 443 444

No comments

Cisco 4G-LTE-ANTM-O-3 Installation Guide Page 418