Cisco 4G-LTE-ANTM-O-3 Installation Guide Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 444
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
Table 9: Supported Interfaces and Associated Port Labels by Cisco Router
Port LabelInterfaceRouter
LAN, FE0FE3
4-port Fast Ethernet LANCisco 819 Router
GE WAN 0Gigabit Ethernet WAN
SerialSerial
3G RSVDMini USB for 3G port Provisioning
CON/AUXConsole/Aux port
There are two labels for the associated antennas with the labels: Main and DIV/GPS.Note
Default Configuration
When you first boot up your Cisco router, some basic configuration has already been performed. All of the
LAN and WAN interfaces have been created, console and vty ports are configured, and the inside interface
for Network Address Translation (NAT) has been assigned. Use the show running-config command to view
the initial configuration, as shown in the following example for a Cisco 819 ISR:
Router# show running
Building configuration...
Current configuration : 977 bytes
!
version 15.1
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
no aaa new-model
ip source-route
ip cef
no ipv6 cef
license udi pid CISCO819G-G-K9 sn FHK1429768Q
controller Cellular 0
interface Cellular0
no ip address
encapsulation ppp
interface Ethernet-wan0
no ip address
shutdown
duplex auto
speed auto
interface FastEthernet0
interface FastEthernet1
interface FastEthernet2
interface FastEthernet3
interface Serial0
Cisco 800 Series Integrated Services Routers Software Configuration Guide
16 OL-31704-02
Basic Router Configuration
Default Configuration
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 443 444

Comments to this Manuals

No comments