Cisco NM-NAM= Datasheet download pdf (Page 29)

Network Analysis Module (NM-NAM)

How to Configure and Manage the Network Analysis Module (NM-NAM)

Cisco IOS Release: Multiple releases (see the Feature History Table)

Enabling NAM Packet Monitoring: Example

In the following example, NAM packet monitoring is enabled on the serial interfaces:

interface Serial 0/0

ip address 172.20.105.213 255.255.255.240

ip route-cache flow

speed auto

full-duplex

analysis-module monitoring

no mop enabled

interface Serial 0/1

ip address 172.20.105.53 255.255.255.252

ip route-cache flow

duplex auto

speed auto

analysis-module monitoring

interface Analysis-Module 2/0

ip address 10.1.1.1 255.255.255.0

hold-queue 60 out

What to Do Next

Proceed to the “Enabling and Accessing the NAM Traffic Analyzer” section on page 29.

Enabling and Accessing the NAM Traffic Analyzer

This section describes how to enable and access the NAM Traffic Analyzer (web GUI).

Prerequisites

• Make sure that your web browser supports your NAM software release. For a list of supported

browsers, refer to the NAM software release notes.

• If you plan to use the HTTP secure server (HTTPs), then you must first download and install the

NAM software K9 crypto patch. Until you install the patch, the ip http secure commands are

disabled. You can download the NAM software K9 crypto patch from Cisco.com.

Restrictions

You can use the HTTP server or the HTTP secure server, but you cannot use both simultaneously.

SUMMARY STEPS

1. Open a NAM console session from the router. See the “Opening and Closing a NAM Console

Session from the Router” section on page 18.

Open a Telnet or SSH session to the NAM. See the “Opening and Closing a Telnet or SSH Session

to the NAM” section on page 38.

2. ip http server enable

ip http secure server enable

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

No comments

Cisco NM-NAM= Datasheet Page 29