Cisco NM-NAM= Datasheet download pdf (Page 57)

Network Analysis Module (NM-NAM)

interface analysis-module

Cisco IOS Release: Multiple releases (see the Feature History Table)

interface analysis-module

To configure the Analysis-Module interface on the router that connects to an installed Network Analysis

Module (NM-NAM), use the interface analysis-module command in global configuration mode. This

command does not have a not form.

interface analysis-module slot/unit

Syntax Description

Defaults The interface is not configured.

Command Modes Global configuration

Command History

Usage Guidelines The Analysis-Module interface is a Fast Ethernet interface on the router that connects to the internal

interface on the Network Analysis Module (NM-NAM).

This type of interface cannot be configured for subinterfaces or for speed, duplex mode, and similar

parameters. See the command-line interface (CLI) help for a list of valid parameters.

The interface analysis-module command enters Analysis-Module interface configuration mode.

Examples The following example shows how to configure the Analysis-Module interface when the NM-NAM is in

router slot 1:

Router(config)# interface analysis-module 1/0

slot Number of the router chassis slot for the network module.

/unit Number of the daughter card on the network module. For NM-NAM, always

use 0. The slash (/) between the slot and unit arguments is required.

Release Modification

12.3(4)XD This command was introduced on the following platforms:

Cisco 2600XM series, Cisco 2691, Cisco 3660, Cisco 3725, and Cisco 3745.

12.3(7)T This command was integrated into Cisco IOS Release 12.3(7)T.

12.3(8)T4 This command was implemented on the following platforms: Cisco 2811,

Cisco 2821, and the Cisco 2851 series.

12.3(11)T This command was made available on the Cisco 3800 series.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 75 76

No comments

Cisco NM-NAM= Datasheet Page 57