Network Analysis Module (NM-NAM)
Configuration Examples for the Network Analysis Module (NM-NAM)
47
Cisco IOS Release: Multiple releases (see the Feature History Table)
Configuration Examples for the Network Analysis Module
(NM-NAM)
This section provides the following configuration examples:
• NAM Management Interface Is Internal and Analysis-Module Interface Is Assigned an IP Address:
Example, page 47
• NAM Management Interface Is Internal and Analysis-Module Interface Is IP Unnumbered:
Example, page 49
• NAM Management Interface Is External and Analysis-Module Interface Is IP Unnumbered:
Example, page 51
NAM Management Interface Is Internal and Analysis-Module Interface Is
Assigned an IP Address: Example
In this configuration example:
• The internal NAM interface is used for management traffic.
• IP addresses from the same routable subnet are assigned to the Analysis-Module interface and the
NAM system.
• A static route to the NAM through the Analysis-Module interface is configured.
• The internal NAM interface is used to monitor WAN traffic on interface Serial 0/0, and the external
NAM interface is used to monitor LAN traffic on interface Fast Ethernet 0/0.
• The NM-NAM is installed in router slot 2.
Figure 7 shows the topology used in the example, and the following sections show the router and NAM
configurations:
• Router Configuration (Cisco IOS Software), page 48
• NAM Configuration (NAM Software), page 49
Comments to this Manuals