60 Implementing Cisco InfiniBand on IBM BladeCenter
4.1.5 Hints and tips
The following information might help you resolve connectivity issues with your Linux
installation:
Verify that the HCA can be seen by the operating system.
If the HCA is not detected, use the linux command lspci as shown in Figure 4-36 to
ensure that the operating system can see the card. If the card is not detected, shut down
the blade and ensure that it is properly seated in the blade.
Figure 4-36 Portion of the output of the lspci command showing the InfiniBand HCA
Verify that the HCA ports are active.
Use the command p1info or p2info as shown in Figure 4-37 to check the status of the
HCA ports to ensure that they are active.
Figure 4-37 HCA port 1 information
Ensure that the driver is loaded.
Run the lsmod command to ensure that the driver is loaded as shown in Figure 4-38.
Figure 4-38 Portion of lsmod output showing Linux driver modules
0c:00.0 InfiniBand: Mellanox Technologies MT25208 InfiniHost III Ex (Tavor
compatibility mode) (rev 20)
[root@localhost InfiniServBasic.4.1.0.6.3]# p1info
Port 1 Info
PortState: Active PhysState: LinkUp DownDefault: Polling
LID: 0x0008 LMC: 0
Subnet: 0xfe80000000000000 GUID: 0x0005ad00000508fd
SMLID: 0x0027 SMSL: 0 RespTimeout : 33 ms SubnetTimeout: 1048 us
M_KEY: 0x0000000000000000 Lease: 15 s Protect: Readonly
MTU: Active: 2048 Supported: 2048 VL Stall: 0
LinkWidth: Active: 4x Supported: 4x Enabled: 4x
LinkSpeed: Active: 2.5Gb Supported: 2.5Gb Enabled: 2.5Gb
VLs: Active: 4+1 Supported: 4+1 HOQLife: 4096 ns
Capability 0x02010048: CR CM SL Trap
Violations: M_Key: 0 P_Key: 0 Q_Key: 0
ErrorLimits: Overrun: 0 LocalPhys: 15 DiagCode: 0x0000
P_Key Enforcement: In: Off Out: Off FilterRaw: In: Off Out: Off
[root@localhost InfiniServBasic.4.1.0.6.3]#
ipoib 141792 1 ics_sdp
ics_srp 86356 0
ics_inic 123492 0
ics_dsc 84256 3 ipoib,ics_srp,ics_inic
mt23108vpd 213296 0
Comments to this Manuals