Cisco CX-FEIP-2TX= Installation and con?guration User Manual download pdf (Page 38)

HP OpenView NetMetrix/UX Release Notes version 6.0

October 1, 1998

Known Problems and Work-Arounds

5967–4358 37

Internetwork Response Manager/Agent

Description Non-IP targets must be in same broadcast domain as the agent

performing the test

Details This problem affects tests with these protocols: IEEE 802.2 and Novell

802.3.

These targets will appear unreachable (typically, orange) or unknown

(typically, blue) unless the target system is in the same broadcast domain

as the LanProbe or IRA performing the test. That is, the echo/response

test is not propagated across a router.

Work-Around Conﬁgure non-IP tests using a LanProbe or IRA that is within the same

broadcast domain as the target node.

Description Internetwork Response Manager fails to update status when

community strings are not conﬁgured

Details IRM allows you to create a target on a LanProbe if you do not have the

probe’s community strings, provided that the default community string

“hp_admin” allows at least level-3 access. Further, IRM will update the

status of the target you create. However, it will not update the status of

the Resp_Time_LP or the probe symbol in the DNA submap; these

symbols will be red until the correct community string is conﬁgured.

Work-Around Make sure that you have conﬁgured the correct community strings for

the probes. The get (or read) community string that you specify must

allow at least level-2 access to the probe. For details, refer to page .12 in

DNA User’s Guide.

Description Some probes allow a maximum of only 20 echo tests, instead of

100 echo tests

Details Refer to the description on page 41.

Work-Around None.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 50 51

No comments

Cisco CX-FEIP-2TX= Installation and con?guration User Manual Page 38