Cisco 4G-LTE-ANTM-O-3 Installation Guide download pdf (Page 211)

Ping the WLC from the router to confirm IP connectivity.

Enter the service-module wlan-ap 0 session command to establish a session into the access point.

Confirm that the access point is running an autonomous boot image.

Enter the show boot command on the access point to confirm that the mode setting is enabled.

Autonomous-AP# show boot

BOOT path-list: flash:ap801-k9w7-mx.124-10b.JA3/ap801-k9w7-mx.124-10b.JA3

Config file: flash:/config.txt

Private Config file: flash:/private-config

Enable Break: yes

Manual Boot: yes

HELPER path-list:

NVRAM/Config file

buffer size: 32768

Mode Button: on

Performing the Upgrade

To upgrade the autonomous software to Cisco Unified software, follow these steps:

To change the access point boot image to a Cisco Unified upgrade image (also known as a recovery image

), use the service-module wlan-ap 0 bootimage unified command, in global configuration mode.

Router# conf terminal

Router(config)# service-module wlan-ap 0 bootimage unified

Router(config)# end

If the service-module wlan-ap 0 bootimage unified command does not work successfully, check whether

the software license is still eligible.

Note

To identify the access point’s boot image path, use the show boot command in privileged EXEC mode

on the access point console.

Note

To perform a graceful shutdown and reboot of the access point to complete the upgrade process, use the

service-module wlan-ap 0 reload command in global configuration mode. Establish a session into the

access point, and monitor the upgrade process.

See the Cisco Express Setup for details about using the GUI configuration page to set up the wireless

device settings.

Note

Troubleshooting an Upgrade or Reverting the AP to Autonomous Mode

If the access point fails to upgrade from autonomous to Unified software, perform the following actions:

•

Check to ensure the autonomous access point does not have the static IP address configured on the BVI

interface before you boot the recovery image.

•

Ping between the router/access point and the WLC to confirm communication.

•

Check that the access point and WLC clock (time and date) are set correctly.

Cisco 800 Series Integrated Services Routers Software Configuration Guide

OL-31704-02 183

Configuring Wireless Devices

Performing the Upgrade

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 443 444

Comments to this Manuals

No comments

Cisco 4G-LTE-ANTM-O-3 Installation Guide Page 211

Comments to this Manuals

Related products and manuals for Routers Cisco 4G-LTE-ANTM-O-3