Cisco 15216 EDFA2 Specifications download pdf (Page 189)

9-41

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01

Chapter 9 TL1 Commands

TL1 Commands and Autonomous Messages

9.7.28 RTRV-COND-ALL

Command RTRV-COND-ALL

Generates a report on the condition (state) of all alarms (except environmental alarms). Note that the ccm

does not appear in the response for EQPT alarms.

Note The messages for Loss of Signal (LOS), Gain Out of Range (GAIN), and Loss of Output Power

(LPOUT) are prioritized (in the order just listed) so that only one message can be delivered at one time.

For example, if the ONS 15216 EDFA2 detects both a loss of input signal and a loss of output power at

the same time, it will deliver only the Loss of Signal (LOS) message to the user. This prioritized filtering

of alarms does not occur with the SNMP delivery of alarms of the ONS 15216 EDFA2.

Syntax

RTRV-COND-ALL:[<tid>]::<ctag>::[<condtype>][,,,];

M <ctag> COMPLD

"<aid>,<ccm>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,,<conddescr>"

;

Example 9-30 RTRV-COND-ALL Command and Response

Amp01:ONS15216 EDFA2> RTRV-COND-ALL:Amp01::229::LCRNT1;

Amp01 2002-06-20 14:30:00

M 229 COMPLD

"1,DWDM:MJ,LOS,SA,6-20,14-25-30,,,\"Loss Of Signal\""

"EQPT,EQPT:MN,LCRNT1,NSA,6-20,14-25-30,,,\"Excessive Pump1 Current\""

;

Table 9-35 RTRV-COND-ALL Syntax Description

Parameter Syntax Description

aid Possible values are:

1 Directly affecting the optical signal.

EQPT General parameters of the ONS 15216 EDFA2 (not directly

affecting optical signal or power bus).

conddescr Detailed text description of the event. The conddescr is 1 to 64

characters of ASCII text. See condtype below.

1 ... 188 189 190 ... 280

No comments

Cisco 15216 EDFA2 Specifications Page 189