Cisco InfiniBand 4x User's Guide download pdf (Page 122)

108 Implementing Cisco InfiniBand on IBM BladeCenter

4. Click the button shown in Figure 6-15 to open the Select Ports menu that gives the

option to allow or to deny access to the SRP host through one or more ports. Add check

marks to only one of the two ports as shown in Figure 6-16 and click OK to save the

changes.

Figure 6-16 Configure port masking for the SRP host: Select Ports menu

5. Figure 6-17 shows that the SRP host has access only to the boot LUN through the

SFS3012-1 port 6/1.

Figure 6-17 Port masking configuration view

This completes the port masking configuration process for the Boot over InfiniBand host.

Note: It is critical that a single and unique path is enabled from the host to the boot LUN

for the initial operating system installation to complete successfully. If there is more

than one path from the host to the boot LUN, then the operating system installation will

fail.

Blade 10 (Linux BoIB)

Host access to the

boot LUN through

FC gateway port 6/1

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 173 174

No comments

Cisco InfiniBand 4x User's Guide Page 122