Cisco InfiniBand 4x User's Guide download pdf (Page 81)

Chapter 4. Configuring InfiniBand with QLogic bridges 67

6. Set an IP address as you would with any Ethernet adapter and save your settings. See

Figure 4-50.

Figure 4-50 Local Area Connection Properties

7. Ping another device on the test network to test your connection. If both blades are in the

same chassis, you do not need any external cables as long as a functioning InfiniBand

switch is in one of the supported I/O bays. If the devices are in two separate chassis, you

need an InfiniBand cable to connect the InfiniBand switch modules in the respective

chassis.

4.2.4 QLogic Fibre Channel Bridge: Configuring SRP

In this section, we describe how to configure a connection on a Windows blade to a remote

Fibre Channel storage device using the QLogic InfiniServ drivers and the QLogic InfiniBand

Fibre Channel Bridge Module. The InfiniBand HCA uses Globally Unique IDs (GUIDs) and

Fibre Channel storage devices use World Wide Names (WWNs). The mapping of GUID to

WWN is done on the bridge module. Follow these steps:

1. Windows finds the QLogic InfiniBand Fibre Channel Bridge Module. Select Install from a

specific location and click Next.

2. Click Browse under Include this location in the search. Select the following location

and then click OK.

C:\Program Files\SilverStorm\SilverStorm HCA\storage

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 173 174

No comments

Cisco InfiniBand 4x User's Guide Page 81