Cisco InfiniBand 4x User's Guide download pdf (Page 85)

Chapter 4. Configuring InfiniBand with QLogic bridges 71

12.After you establish the bridge port to remote drive mapping, you need to establish another

mapping from SRP initiator to remote drive. On the bridge Web GUI main menu, click FCP

Device Discovery, and then Start. The remote drives that are mapped to the bridge ports

will show up in Discovered Devices (Figure 4-58).

Figure 4-58 Discovered Fibre Channel Target

13.Click Configure to designate a name for the device (Figure 4-59). This name will be used

later when mapping to an SRP Initiator.

Figure 4-59 Assign name to Fibre Channel Storage Device

14.After you designate a name, click Submit. The remote logical drive moves from

Discovered Devices to Configured Devices (Figure 4-60).

Figure 4-60 Configured Fibre Channel Target

15.Close the FCP Device Discovery window and click SRP map config on the GUI main

menu page. Here, you see your virtual HBAs listed. There will be two IOC headings, one

for each I/O Controller on the bridge module. These correspond to the two VFx Controllers

that you saw in device manager back in step 7:

– If you want to map your target through IOC 1, click the Click To Add link under the

IOC 1 heading.

– If you want to map your target through IOC 2, click the Click To Add link under the

IOC 2 heading.

16.Give the map a name and select a map type, then click Next.

There are two mapping types:

–

Explicit: In an explicit mapping, the host and target LUN numbers must be listed in the

mapping.

–

Direct: In a direct mapping, the host will see all remote drives that are visible to the

port WWNs without a specific LUN being identified.

You address explicit mapping first, and then direct mapping.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 173 174

No comments

Cisco InfiniBand 4x User's Guide Page 85