SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface gigabitethernet slot/port
4.
port-tagging
5.
encapsulation dot1q vlan-id
6.
set cos cos-value
7.
end
DETAILED STEPS
PurposeCommand or Action
Enables the privileged EXEC mode.enable
Step 1
Example:
Router>enable
Enter your password when prompted.
Enters the global configuration mode.configure terminal
Example:
Router#configure terminal
Step 2
Specifies an interface and enters the interface configuration
mode.
interface gigabitethernet slot/port
Example:
Router(config)#interface gigabitethernet 0/2
Step 3
Inserts the VLAN ID into a packet header to identify which
Virtual Local Area Network (VLAN) the packet belongs to.
port-tagging
Example:
Router(config-if)#port-tagging
Step 4
Defines the encapsulation format as IEEE 802.1Q (dot1q),
and specifies the VLAN identifier.
encapsulation dot1q vlan-id
Example:
Router(config-if-port-tagging)#encapsulation
dot1q 10
Step 5
Sets the Layer 2 class of service (CoS) value to an outgoing
packet end.
set cos cos-value
Example:
Router(config-if-port-tagging)#set cos 6
Step 6
Cisco 800 Series Integrated Services Routers Software Configuration Guide
48 OL-31704-02
Configuring Ethernet CFM and Y.1731 Performance Monitoring on Layer 3 Interfaces
Configuring the NID
Comments to this Manuals