Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 31)

2-3

Cisco ASA 5500 Series Hardware Installation Guide

OL-10089-01

Chapter 2 ASA 5505

Memory Requirements

The memory requirement for the ASA 5505 is 256MB.

Installing the Chassis

This section contains the following topics:

• Connecting the Interface Cables, page 2-3

• Powering on the ASA 5505, page 2-5

• Installing a Cable Lock, page 2-6

Connecting the Interface Cables

This section describes how to connect the cables to the Ethernet and Console ports.

Warning

Only trained and qualified personnel should install, replace, or service this equipment

Statement 49

Caution Read the safety warnings in the Regulatory Compliance and Safety Information for the Cisco ASA 5500

Series and follow proper safety procedures when performing these steps.

To connect cables to the ports perform the following steps:

Step 1 Place the chassis on a flat, stable surface.

Step 2 Before connecting a computer or terminal to the ports, check to determine the baud rate of the serial port. The

baud rate must match the default baud rate (9600 baud) of the Console port of the adaptive security appliance.

Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow Control

(FC) = Hardware.

Step 3 Connect the cables to the ports.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 81 82

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 31