Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 53)

A-3

Cisco ASA 5500 Series Hardware Installation Guide

78-17374-01

Appendix A Installing and Replacing the SSM

Installing and Replacing the 4GE SSM

Installing the 4GE SSM

Note The following is only supported on the ASA 5510, ASA 5520, and ASA 5540.

To install a new 4GE SSM for the first time, perform the following steps:

Step 1 Power off the adaptive security appliance.

Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare

skin. Attach the other end to the chassis.

Step 3 Remove the two screws (as shown in Figure A-2) at the left rear end of the chassis, and remove the slot

cover.

Figure A-2 Removing the Screws from the Slot Cover

Step 4

Insert the 4GE SSM through the slot opening as shown in Figure A-3.

Figure A-3 Inserting the 4GE SSM into the Slot

Step 5

Attach the screws to secure the 4GE SSM to the chassis.

Step 6 Power on the adaptive security appliance.

Step 7 Check the LEDs. If the 4GE SSM is installed properly the STATUS LED flashes during boot up and is

solid when operational.

Step 8 Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices. For

more information, see the “Connecting the Interface Cables” section.

119642

MGMT

USB2

USB1

POW

STATUS

FLASH

VPN

ACTIVE

132984

MGMT

USB2

USB1

STATUS

Cisco SSM-4GE

POW

STATUS

FLASH

VPN

ACTIVE

MGMT

USB2

USB1

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Comments to this Manuals

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 53

Comments to this Manuals

Related products and manuals for Chassis components Cisco ASA5500-HW - Hardware Accessory Kit Network Device