Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide download pdf (Page 77)

C-1

Cisco ASA 5500 Series Hardware Installation Guide

OL-10089-01

APPENDIX

Cable Pinouts

This appendix describes pinout information for 10/100/1000BaseT ports, console and the RJ-45 to DB-9

ports, and the Management 10/100/1000 Ethernet port, and includes the following sections:

• 10/100/1000BaseT Connectors, page C-1

• Console Port (RJ-45), page C-2

• RJ-45 to DB-9, page C-3

• MGMT 10/100/1000 Ethernet Port, page C-3

• Gigabit and Fibre Channel Ports, page C-4

10/100/1000BaseT Connectors

The adaptive security appliance supports 10/100/1000BaseT ports. You must use at least a Category 5

cable for 100/1000baseT operations, but a Category 3 cable can be used for 10BaseT operations.

The 10/100/1000BaseT ports use standard RJ-45 connectors and supports MDI and MDI-X connectors.

Ethernet ports normally use MDI connectors and Ethernet ports on a hub normally use an MDI-X connector.

Use an Ethernet straight-through cable to connect an MDI to an MDI-X port. Use a cross-over cable to

connect an MDI to an MDI port, or an MDI-X to an MDI-X port.

Figure C-1 shows the 10BaseT and the 100BaseTX connector (RJ-45).

Figure C-1 10/100 Port Pinouts

H5318

231 45678Pin Label

RD+

RD-

TD+

TD-

1 2 ... 72 73 74 75 76 77 78 79 80 81 82

No comments

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Installation Guide Page 77